The mill hinged is intended for loosening of the top layer of peat on peat bogs with various mechanical structure.
The processed layer of peat has to be cleaned from stubs and other foreign matters which can be the cause of breakage of knots and details of a mill.
To use a mill only according to instructions of the producer and in technically working order.
The producer does not bear responsibility when using a mill not for stated above is more whole, at change of a design of the unit without coordination with the manufacturer.
The producer reserves the right for introduction of constructive improvements which are not described in this instruction.
The mill hinged consists of three sections. The central section is established on levers of the hinged device of the tractor, side sections, fasten to central from each party on two fingers and chains. On a frame there are fingers for installation of additional freights.
Working bodies of a mill are passive shaft with knives of triangular shape. Knives are placed on a shaft surface in the form of a four-way spiral with an angle of lead of a spiral 83 °.
Shaft are located at an angle 20 ° concerning a unit frame.
At a mill of FNP-10(8)/9.0 extreme sections in relation to average are suspended on chains which hold sections during raising of a mill by means of the hinged device of the tractor.
Basic model
|
FNP-10/9.0
|
FNP-8/9.0
|
Type
|
hinged
|
Operating width, m.
|
9
|
Quantity of shaft, piece.
|
5
|
Length of a knife, cm
|
10
|
8
|
Total number of knives, piece.
|
400
|
480
|
Angle of lead of knives, degrees
|
83
|
83
|
Max. operating depth, mm
|
100
|
80
|
Corner of the direction of shaft, degrees
|
20
|
Max. operating speed, km/h
|
15
|
side-member
|
Fastens on fingers it is regulated by chains
|
Bearing mount assembly
|
UCFL 306
|
Overall dimensions, mm.:
- length
- width
- height
|
1250
9200
1400
|
Weight, kg.
|
800
|